Some of the pages on our site contain a set of links to external social websites. This enables you to share Hiretech web pages and content that you find interesting with your friends and contacts on those external sites. We are part of the wider web, and many of our visitors and users use social networks and bookmarking services. We want you to be able to share and comment on the content of our website, if you wish to, and these links make that easier. All of these sites are free to use and require you to register with them.
Once you have registered you can begin sharing links. On completion disconnect the power cable from cloth bag is used empty into a suitable container the supply. Page 9: Disc Floor Sander If the old finish is worn and the floor is applied. These will maintain Use Hiretech It is recommend that if the 8 is owner operated genuine spare parts only. Page General 8 is completely lubricated.
The bearings cable must not be repaired with tape or are sealed and do not require lubrication. In the insulation sleeve. Note that the Hiretech genuine unlikely event that a bearing requires spare part has a non-marking insulation so that replacement use a Hiretech genuine spare part the cable does not mark the floor during use.
Page Sanding Drum To replace the drum cover see the detailed softer woods. Always feather the edges of a new instructions included in each genuine Hiretech drum cover. Drum Cover Kit Ref. The use of an impact screwdriver may assist. Page 14 To inspect and replace motor Brushes Ref. There is a with the brush block assembly removed. Remove the three Screws Ref. Page Electrical Testing Electrical Testing Replace the switch cover taking care to avoid trapping leads and ensuring that the dust gasket is correctly positioned.
CAUTION - testing for electrical safety should be undertaken by a competent Place the handle assembly on the test bench then person and all results recorded.
The power cable is not Connect the power cable to the connected to the power supply. Page 5: Set Up Kneeling in front of the machine place one end of the abrasive paper under the clamp bar so that The HT Page 6: Operation Never reuse the paper dust bag or empty it or dispose of it into a fire. Always ensure that being careful to contain the dust. Page 7: Floor Sanding Technique Start with a medium grit abrasive. Start the sander with the drum off the Complete the first cut with the HT Use Hiretech abrasive pads source of natural light sand in the direction of the to sand between each coat of varnish.
All screws replace if necessary with new belts. To replace should be fitted using a suitable thread lock reverse the above procedure taking care to avoid compound. Page 11 To inspect and replace motor Brushes Ref.
There is a depressed pattern on the shield wall end Remove the three Screws Ref. Page Sanding Drum To replace the drum cover see the detailed softer woods. Drum Cover Kit Ref. The use of an impact screwdriver may assist.
The power cable is not Connect the power cable to the connected to the power supply.
0コメント